Our answer
On our planning profile the Anker SOLIX C2000 Gen 2 runs a 12V portable fridge for about 99 hours, or 79 hours if you keep a reserve back.
The checks behind this answer
Stored energy is the final check, not the first. Voltage, continuous output, and startup demand must clear before runtime means anything. Missing published evidence stays marked unverified instead of being treated as a pass.
| Check | Result | Why |
|---|---|---|
| Voltage | Clears | A 12V portable fridge runs on 12V and the Anker SOLIX C2000 Gen 2 supplies 120V AC. |
| Continuous output | Clears | A 45W running load sits inside the 2,400W continuous rating, leaving about 5233% headroom. |
| Startup demand | Clears | The 120W start is covered by continuous output alone, so no surge rating is needed. |
| Inverter self-consumption | Unverified | This is a long, low-power load, so the inverter's own draw materially changes the answer. That figure is not published for this station. |
How the number is built
A battery holds back some of its rated capacity, and converting to household AC costs more on top. Of the 2,048Wh rated here, roughly 1,622Wh reaches the outlet under a conservative planning model.
That energy meets an average load of 16.4W, which applies a 35% duty cycle to a 45W running draw. Holding back a 20% reserve for battery age, cold, and a longer outage leaves 79 hours. These are calculations, not measurements from a test.
What we could not verify
These gaps are in the published evidence, not in the arithmetic. Each one is a reason to check before you depend on this pairing.
- Inverter self-consumption is not published, and it matters more than the appliance load on a run this long.
Replace our assumptions with your own
Running this fridge from the DC socket instead of the inverter is usually worth 10 to 15 percent more runtime, because the station never has to convert to AC and back.
Check the rated current on the fridge label, then run it for 24 hours in the conditions you actually expect and read the station's own DC output meter.
Continue through this cluster
Use the next page that answers your unresolved constraint
Evidence used on this page
Important fields are tied to a specific source. Manufacturer claims, government guidance, calculations, and planning assumptions remain separate.
- Anker SOLIX C2000 Gen 2 specifications
Anker SOLIX US
Published specification table plus the on-page comparison chart for weight and expandability.
official product page
- Calculation and compatibility methodology
Power Station Station
Defines the capacity, efficiency, reserve, duty-cycle, voltage, continuous-output, and startup checks applied across the site. Planning defaults are visible on every page that uses them.
planning assumption
- Anker SOLIX C2000 Gen 2 specifications
Anker SOLIX US
Full input and output table including the XT-60i PV input window and current limit, all three AC output paths, per-port USB ratings, car charger output and UPS time.
official product page
- Anker SOLIX "Compare Products" tool, C2000 Gen2 column
Anker SOLIX US
Anker's own comparison tool. Source for AC outlet counts, per-port USB wattage, car auxiliary rating, AC input and the MPPT current limit. Its receptacle type labels are not used: it prints "NEMA 6-20" for outlets it annotates as 120V.
official product page