Our answer
On our planning profile the Anker SOLIX C2000 Gen 2 runs a window air conditioner for about 5.4 hours, or 4.3 hours if you keep a reserve back.
The checks behind this answer
Stored energy is the final check, not the first. Voltage, continuous output, and startup demand must clear before runtime means anything. Missing published evidence stays marked unverified instead of being treated as a pass.
| Check | Result | Why |
|---|---|---|
| Voltage | Clears | A window air conditioner runs on 120V and the Anker SOLIX C2000 Gen 2 supplies 120V AC. |
| Continuous output | Clears | A 500W running load sits inside the 2,400W continuous rating, leaving about 380% headroom. |
| Startup demand | Clears | The 1,800W start is covered by continuous output alone, so no surge rating is needed. |
How the number is built
A battery holds back some of its rated capacity, and converting to household AC costs more on top. Of the 2,048Wh rated here, roughly 1,622Wh reaches the outlet under a conservative planning model.
That energy meets an average load of 300.8W, which applies a 60% duty cycle to a 500W running draw. Holding back a 20% reserve for battery age, cold, and a longer outage leaves 4.3 hours. These are calculations, not measurements from a test.
Replace our assumptions with your own
Inverter-driven units ramp up gently and cycle far less, which changes both the surge question and the energy total. A conventional single-speed unit is the harder case on both counts.
Read the nameplate or data label for voltage and rated amps or watts, then run the appliance through a normal cycle on a plug-in energy meter for 24 hours. Use the measured watt-hours in the calculator instead of the default on this page.
Continue through this cluster
Use the next page that answers your unresolved constraint
Evidence used on this page
Important fields are tied to a specific source. Manufacturer claims, government guidance, calculations, and planning assumptions remain separate.
- Anker SOLIX C2000 Gen 2 specifications
Anker SOLIX US
Published specification table plus the on-page comparison chart for weight and expandability.
official product page
- Certified room air conditioners
ENERGY STAR
Cooling capacity and combined energy efficiency ratio by model. Used to derive representative running watts from BTU capacity.
government data
- Calculation and compatibility methodology
Power Station Station
Defines the capacity, efficiency, reserve, duty-cycle, voltage, continuous-output, and startup checks applied across the site. Planning defaults are visible on every page that uses them.
planning assumption
- Anker SOLIX C2000 Gen 2 specifications
Anker SOLIX US
Full input and output table including the XT-60i PV input window and current limit, all three AC output paths, per-port USB ratings, car charger output and UPS time.
official product page
- Anker SOLIX "Compare Products" tool, C2000 Gen2 column
Anker SOLIX US
Anker's own comparison tool. Source for AC outlet counts, per-port USB wattage, car auxiliary rating, AC input and the MPPT current limit. Its receptacle type labels are not used: it prints "NEMA 6-20" for outlets it annotates as 120V.
official product page