Skip to main content
Power Station StationIndependent power planning
Menu

Runtime calculation

How Long Will an Anker SOLIX C300 Run a Refrigerator

This estimate separates electrical compatibility from battery endurance. Published specifications control where they exist, and every planning default is labelled where the manufacturer leaves a gap.

Research by the Power Station Station Editorial Team

Estimated runtime
4.4 hours
From 288Wh rated capacity against a 51.5W average load.
Continuous output
300 W
What the inverter can sustain. Output decides whether the appliance runs at all.
Published peak
Not published
Anker SOLIX does not publish a general surge rating for this model, so motor starts need model-level verification.

Our answer

On our planning profile the Anker SOLIX C300 runs a household refrigerator for about 4.4 hours, or 3.5 hours if you keep a reserve back.

The checks behind this answer

Stored energy is the final check, not the first. Voltage, continuous output, and startup demand must clear before runtime means anything. Missing published evidence stays marked unverified instead of being treated as a pass.

Electrical checks applied to this station and appliance pairing
CheckResultWhy
VoltageClearsA household refrigerator runs on 120V and the Anker SOLIX C300 supplies 120V AC.
Continuous outputClearsA 150W running load sits inside the 300W continuous rating, leaving about 100% headroom.
Startup demandUnverifiedThe 1,200W start exceeds continuous output, and Anker SOLIX does not publish a general surge rating for this model. Treat the pairing as unproven until you verify it.

How the number is built

A battery holds back some of its rated capacity, and converting to household AC costs more on top. Of the 288Wh rated here, roughly 228Wh reaches the outlet under a conservative planning model.

That energy meets an average load of 51.5W, which applies a 33% duty cycle to a 150W running draw. Holding back a 20% reserve for battery age, cold, and a longer outage leaves 3.5 hours. These are calculations, not measurements from a test.

What we could not verify

These gaps are in the published evidence, not in the arithmetic. Each one is a reason to check before you depend on this pairing.

  • Anker SOLIX C300 has no published surge rating, so a 1,200W start cannot be confirmed.
  • Neither manufacturer publishes how long the surge is held, so the margin above continuous output cannot be verified against a duration.

Before you rely on this

These limits decide whether this appliance belongs on a portable battery at all.

  • A closed refrigerator keeps food safe for about four hours without power. Backup power can extend that, but the temperature still needs checking.

Replace our assumptions with your own

Room temperature, how often the door opens, how full the refrigerator is, the age of the door seals, and whether an automatic defrost cycle falls inside the outage all move the daily energy figure more than the model name does.

Read the nameplate or data label for voltage and rated amps or watts, then run the appliance through a normal cycle on a plug-in energy meter for 24 hours. Use the measured watt-hours in the calculator instead of the default on this page.

Continue through this cluster

Use the next page that answers your unresolved constraint

Everything a Anker SOLIX C300 can runCompare this answer against the other loads the same station covers.Household refrigerator power requirementsWork through the load itself before choosing hardware for it.Anker SOLIX C300 specifications and sourcesSee where every number on this page came from.All Anker SOLIX recordsCompare the rest of the range.Runtime calculatorReplace our planning defaults with your own measurements.

Evidence used on this page

Important fields are tied to a specific source. Manufacturer claims, government guidance, calculations, and planning assumptions remain separate.

  1. Capacity, output, SurgePad rating, ports, weight, warranty, and UPS read from the rendered comparison table. The solar voltage window comes from the same page’s published FAQ.

    official product page

  2. Model-level annual energy use and product attributes. It supports the energy figures used here. It does not validate any startup or surge preset.

    government data

  3. Supports the four-hour closed-refrigerator and 48-hour full-freezer guidance.

    government guidance

  4. Defines the capacity, efficiency, reserve, duty-cycle, voltage, continuous-output, and startup checks applied across the site. Planning defaults are visible on every page that uses them.

    planning assumption

  5. Solar input connector and voltage window from FAQ Q2, per-port USB behaviour from FAQ Q3, AC outlet rating from FAQ Q4, car outlet and port count from the comparison strip.

    official product page

  6. Anker's own comparison tool. Source for AC outlet counts, per-port USB wattage, car auxiliary rating, AC input and the MPPT current limit. Its receptacle type labels are not used: it prints "NEMA 6-20" for outlets it annotates as 120V.

    official product page