Skip to main content
Power Station StationIndependent power planning
Menu

Runtime calculation

How Long Will a Goal Zero Yeti 700 Run a TV

This estimate separates electrical compatibility from battery endurance. Published specifications control where they exist, and every planning default is labelled where the manufacturer leaves a gap.

Research by the Power Station Station Editorial Team

Estimated runtime
6.3 hours
From 677.37Wh rated capacity against a 85W average load.
Continuous output
600 W
What the inverter can sustain. Output decides whether the appliance runs at all.
Published peak
1,000 W
Manufacturer surge figure, used only for the startup check.

Our answer

On our planning profile the Goal Zero Yeti 700 runs a television for about 6.3 hours, or 5 hours if you keep a reserve back.

The checks behind this answer

Stored energy is the final check, not the first. Voltage, continuous output, and startup demand must clear before runtime means anything. Missing published evidence stays marked unverified instead of being treated as a pass.

Electrical checks applied to this station and appliance pairing
CheckResultWhy
VoltageClearsA television runs on 120V and the Goal Zero Yeti 700 supplies 115V AC.
Continuous outputClearsA 85W running load sits inside the 600W continuous rating, leaving about 606% headroom.
Startup demandClearsThe 100W start is covered by continuous output alone, so no surge rating is needed.

How the number is built

A battery holds back some of its rated capacity, and converting to household AC costs more on top. Of the 677.37Wh rated here, roughly 536Wh reaches the outlet under a conservative planning model.

That energy meets an average load of 85W, which applies a 100% duty cycle to a 85W running draw. Holding back a 20% reserve for battery age, cold, and a longer outage leaves 5 hours. These are calculations, not measurements from a test.

Replace our assumptions with your own

Brightness setting matters more than screen size on modern sets. A television in a bright-room picture mode can draw twice what the same set uses in a calibrated mode.

Read the nameplate or data label for voltage and rated amps or watts, then run the appliance through a normal cycle on a plug-in energy meter for 24 hours. Use the measured watt-hours in the calculator instead of the default on this page.

Continue through this cluster

Use the next page that answers your unresolved constraint

Everything a Goal Zero Yeti 700 can runCompare this answer against the other loads the same station covers.Television power requirementsWork through the load itself before choosing hardware for it.Goal Zero Yeti 700 specifications and sourcesSee where every number on this page came from.All Goal Zero recordsCompare the rest of the range.Runtime calculatorReplace our planning defaults with your own measurements.

Evidence used on this page

Important fields are tied to a specific source. Manufacturer claims, government guidance, calculations, and planning assumptions remain separate.

  1. Published specification table covering capacity, chemistry, lifecycles, inverter output, solar input window, weight, and warranty.

    official product page

  2. On-mode power and standby power by screen size and technology.

    government data

  3. Defines the capacity, efficiency, reserve, duty-cycle, voltage, continuous-output, and startup checks applied across the site. Planning defaults are visible on every page that uses them.

    planning assumption

  4. Published specification table: inverter output and waveform, every DC and USB port with its rating, the solar input window and current limit, AC charge input, and expansion.

    official product page